on 07-21-2005 2:19 PM
Hello Friendz,
I am trying to add the corrected data from psa to infocube.But,its taking so much time to process the same request again i.e. its going packet by packet again.
Since last 3 hours i am waiting for data to get uploaded in infocube.
Is there any solution on this?
Hi Steve
There could be differefnt reason behind this delay
Is your data is huge?
It could also be possible that data you are trying upload is not correct.
or There must some routine in update rule which is taking time. may be it has end less loop.
So i would suggest you to wait till the requets becomes red to get the right picture. It could also be possible that it will end up giving dump.
Check out the status of the upload in detail tab in monitor.
Regards,
Rohini
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
how much time dit it take during the initial run?
It will take similar amount of time even during the reconstruction also, less the time it took to extract from sourcesystem. It has to go packet by packet, and the data will flow thru the transfer rules, update rules etc.
there is no short cut here. Have u checked to see there are no dumps? check ST22.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
88 | |
10 | |
10 | |
9 | |
7 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.