on 07-21-2005 11:05 AM
We have an Infopackage Group to Load Transaction Data.
In the particular Infopackage group it has total of 15 loads.
The problem is the first 6 Loads are getting scheduled automatically and after that the loads are getting stopped.
From the 7th Load to 15th Load i am scheduling the loads manually.
Before one week or so all loads of the infopackage group were getting scheduled automatically.
What should be the problem.
Thanks in Advance
Anil
Try stopping the Job and starting it again from the Schedule tab of the InfoPackage group.
Doesn't seem to be the case for you, but if you had the IPKG group scheduled to run 7 loads and then added 8 more with a transport or manually, the new loads will not be picked up unless you stop the current job and start it again.
Vineet
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Anil,
Unable to guess what else could have gone wrong.
Bye
Dinesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Anil,
I guess you would need to check the 6th load and 7th load. Is the 6th load smooth?. Where does it load - ODS/Cube?. If it is ODS does the activation happen smoothly. Also check if there is any time lag defined between the various infopackages.
Bye
Dinesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Rohini,
I think he is using Infopackage groups not Process chains to load data?
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Anil,
In the infopackage group check whether all the infopackages are checked for execution. It is the first check box.
Bye
Dinesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Anil,
Your data was gettign uploadad automatically due to process chain, so check out if your process chain got deactivated due to some reason. may you can reactivate and excute your process chain to start the upload automatically. Also check if your upload is checked for periodic upload.
Regards,
Rohini
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
74 | |
9 | |
7 | |
6 | |
6 | |
6 | |
6 | |
6 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.