.xbw file goes corrupted and shows error on opening the project some time later

[vivek_m]

Hi,

I have a working mobile workflow deployed on server and is working on connecting using iPhone, iPad and Android. but when opening the same project and its Workflow editor some time later it shows references could not found error. please find attached the error file below.

Because of the above problem i have to again start it from begining and redeploy it.

Can any one help me to solve this headache.

Thanks,

Vivek

[Former Member · Accepted solution]

As shown in the PNG there are definately errors from the package parser though it may be intermittent. Also I could see lot of warning which may point you to the real problem.

Is it very hard to understand the problem without having the package, is it possible to upload the package.

[vivek_m · Accepted solution]

Anand,

Of-course, i accept that there are lot of warnings. Those are because of the certain screen controls which needs to be provided with key and also those keys are not binded to any data. Its not a must that we should have keys binded to data fields. But its mandatory that a control that we place on the screen should have a key. So these warnings are subjected to such things saying that they are not binded to a data field.

Also without solving the errors its not possible for us to upload the package. But if we don't have any error and have only warnings then its possible for us to upload the package.

As per your reply i just now tried to solve the warnings and when again saved it, i as not able to see the errors. Am not sure about the errors, how they vanished as of a sudden. Here i have attached the png for reference. But still the warnings are there.

Thanks,

Vivek

[david_brandow]

The likeliest explanation is the the project with the MBOs in it has been renamed. Another possibility is that the MBOs themselves have been renamed. Rather than recreating your workflow, you should just be able to update the reference, go to the Flow Diagram, right click in the whitespace, and you should see an operation for displaying the MBO references, which you can then edit and point them at the correct location.