on 10-22-2012 10:07 AM
Hello Everyone
I have put mrp type VB ,Lot size FX ,Reorder Point 500;Fixed lot size 600 nad Individual/co 2 in mrp 4 and stock is below reorderin point but still not pr
is not genereted through md50 as well as md02
how to generet pr for reordering point
thanx
Sushant
Dear Sushant,
Run MRP using T.Code MD03 and check the results in MD04.
Regards
Mangalraj.S
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear Sushant,
Check with these MRP control parameters, 1,3,1,3,1 and also ensure no plant specific material status
which blocks for MRP/Purchasing is not set in the material master.
Also ensure that there is no other procurement proposal exists in the system for the mentioned material
in MD04.Only if the stock is less than the reorder point and no other procurement proposal exists,then
MRP run through MD03 will propose a new PR.
Regards
Mangalraj.S
Hi mangal & avinash
its work. In md04 open PO or Pr should not be there then Pr is created
Thanx
Sushant
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Sushant,
Also check your procurement type it should be 'F' as you are looking for Purchase Requisition. That is you are running MRP with 'Create Purchase Req.' should be either 2 or 3.
Now I am doubtful, because initially you said you are running with MD02(which is single item and Multi-level) which we generally use for Materials that are to be produced in-house. And in this case you were looking for PR. Now if your Material is a In-House produced Material then use MD02 with 'Create Purchase Req.' = 3(Planned Order).
And in this case you should be looking for Planned Order.
Please check accordingly depending in-house or Externally Procured. If it is Both(Procurement type = X) then also you must run MRP with and expectation generating Planned Order.
Regards,
Avinash.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Sushant,
Please have a check in MD04 if you already have any open Incoming Receipt(PR or Purchase Order). Or since you mentioned Indvid/Coll indicator as ' 2'(Check for any Planned Order or Open Production Order).
The settings that you have given is pretty much fine. Check and revert !!
Regards,
Avinash
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
99 | |
11 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.