on 10-21-2012 3:22 AM
Dears
Pls see below step i was in stuck and expect some tips to move further
I was created a characteristic by using CT04 and in value tab give range as 0 - 100
and created a MIC with reference to above characteristic
and it is assign in inspection plan and it working fine
Now business want to remove range from the MIC so system should accept all value during RR
For this i done following step
remove the value in change mode of CT04
but in MIC i was not able re remove the value..system is asking upper limit and lower limit as mandatory
Pls tell me how to remove the value in this case as reference characteristic
Abu fathima
1.If you are using class char to trasfer result to Batch ,then
-Make change in CT04
-Create New MIC with reference to this change
-asssign same in the task list by removing original one !
2.If class char is not used for trasfer result to Batch ,then directly visit the Task list >unlock MIC from edit > remove the limits & save.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
106 | |
12 | |
11 | |
6 | |
5 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.