Update mode F not supported by the extraction api

[Former Member]

I am trying to load 0FS_CTR_NO (loads contract numbers as master data) and 0CML_INIT_BUDAT (initialises an InfoCube).

In BW, I schedule a delta initialisation(0FS_CTR_NO) or initialise delta status (0CML_INIT_BUDAT) and no packets are returned.

In R/3, in RSA3, the error message is: Update mode F not supported by extraction api. However, I cannot change the update mode in the test run from "F" to "C" (delta initialisation) as the field is greyed out in R3.

[Former Member · Accepted solution]

ilan

i have faced same problem to . when your uploading master data. you can try this way. delete your datasource assignment and reassign and replicate the datasources once agian . if u find ur transfer structure active state but try to activate it once again manually . create info package upload . this may help you .

assign points if helps

[Former Member]

0FS_CTR_NO uses function module FVD_BCT_RANL_GET for the extraction. You should check this function module, if it allows full update. But usually every datasource supports a full update.