Skip to Content

Error Sending System Measurement via USMM to SAP

I'm a newbie to starting a discussion, so please try to bare with me.

I am tryng to send our system measurement results to SAP via USMM. When I click on "Send to SAP" I get the following error message:

Missing setting in table /BDL/TASK_ATTR

Message no. /BDL/BDL3010

I have searched Google and SAP Marketplace and have found nothing to help me at all.

In my production ECC system there are 9 entries in SE16 for /BDL/TASK_ATTR, however, in my producton SRM system there are 0 entries.

How do I add entries into this table, should I? SM30, SM31, and SE16 will not let me. Do I want the entries from my ECC system added to the my SRM system? Has anyone experienced this before and if so, what did you do to resolve this?

Thank you,


Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

3 Answers

  • Oct 05, 2012 at 05:37 PM

    I should also mention that SDCCN has been activated, it shows that is has. I found where I can add the entries in SE16 (I will have to transport up), but do I want to and if so, do I enter the same entries as my ECC system?

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hi Robin,

      There should be 9 entries and you can do this logging by logging into client 000 and running tcode SE16 --> Table /BDL/TASK_ATTR --> Create. Validate that you have SEND_DATA set.

      Here are the main entries below.



      ADDON_DOWNLOAD SDCC B Create session Add-on(s)
      DELETE_OLD_SDCC_DATA SDCC B Delete old session and log data
      EXPORT_DOWNLOAD SDCC D Export session data to file
      MAINTAIN_SDCC SDCC B Maintenance Package
      REQUEST_DATA SDCC B Request session data
      RTCCTOOL RTCCTOOL D Service Preparation Check
      SEND_DATA SDCC B Send session data
      SERVICE_DEFINITION_REFRESH SDCC B Refresh service definitions
      SESSION_REFRESH SDCC B Refresh sessions

      Also, is your SRM system on the same ST-A/PI level? You might could run SE38 --> RTCCTOOL to validate you can connect to SAP.

      Hope this information helps!


  • Oct 08, 2012 at 05:34 PM

    Thank you Teresa, it was helpful.

    I added the entries as you listed, but still get the error

    Missing setting in table /BDL/TASK_ATTR

    Message no. /BDL/BDL3010

    We only have ST-PI in our SRM systems. RTCCTOOL shows that we are missing note 91488. I was hoping there was some kind of work around as it is a production system and it will have to be in a project to apply ST-A/PI . It's looking like there may be no way around that. Is there some other entry that could be made without me having to start a project? Other than ST-A/PI, is there anything else that would need to go in?

    Thank you,


    Add comment
    10|10000 characters needed characters exceeded

  • Oct 08, 2012 at 05:44 PM

    This is what we have: ST-PI Release 2008_1_700 level 6

    Add comment
    10|10000 characters needed characters exceeded