on 10-04-2012 4:07 PM
Hi BI experts
I have defined a key figure with 8 decimals places. When loading into PSA all 8 decimal places are shown.
If you load them further to a DSO or InfoCube it will show only 3 decimals places.
Where is it possible to influence this behaviour?
Thanks
Thomas
Hi,
Check this out:
Hope that helps.
Regards,
AL
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi AL
I need more than 3 places after the decimal point.
As described in note 460652 it is only possible for amount key figures before the decimal point.
Thanks
Thomas
Hi Thomas,
I see two alternatives:
1. Introduce a new "number" key figure (e.g. of data type DEC) and store the currency key in a characteristic (of data type CHAR). Define your own domain according to Note 460652 to customize the new domain to meet your requirements in length and/or precision.
2. If only the precision is needed during calculations, you might consider to multiply the key figure with e.g. 1,000. Át the end divide the key figure by 1,000.
Best regards,
Sander
Hi Thomas,
Please refer to the following SAP Notes:
Best regards,
Sander
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
90 | |
10 | |
10 | |
10 | |
7 | |
7 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.