error using tcode cn24n

[former_member1195941]

hi,

while accessing the tcode cn24n,i am getting the error "No order corresponding to the selection criteria"

Please resole the issue. 

[Former Member]

Hi Neha,

Try this note,

Note 793742 - Collective release - selection conditions deleted

It does not talk about the exact issue that you are facing but the cause may be the same. The text in the note states the cause as mentioned below,

"The problem is due to the system design.
Instead of returning to the initial screen, the transaction calls itself again. Therefore all fields, for which the values were not memorized in SET/GET parameters, are initial."

Take help from your ABAPer to do the required modification.

Regards,

Gokul

[former_member1195941]

Hi Gokul,

Thanks for your support.

While executing CN24N in some project only i am getting this message and other project is executing properly.

Please help.

[Former Member]

Hi Neha,

Please carry out configuration at following path.

SPRO -> Project System -> Dates--> Scheduling--> Define Levels for Network.

Check IMG Activity documentation for this config and then see you are getting desired result.

Regards

Tushar

[former_member1195941]

Hi Tushar,

I had tried this configuration but still getting the same message.Please help.

"No order corresponds to selection criteria"

Message no. CO176

[Former Member]

Hi,

Check the note i posted below and investigate the matter with your ABAPer's.

In the meanwhile try using CN24 instead of CN24N and see if it satisfies your purpose.

Regards,

Gokul

[Former Member]

Hi,

Try using only Network Header number instead of Project definition number and let us know what you are seeing.

Regards,

Sudhakar

[former_member1195941]

Hi Sudhakar,

I had tried with network header also but still getting the same message.please help.