cancel
Showing results for 
Search instead for 
Did you mean: 

Error dtp missing dtpr request

Former Member
0 Kudos

Dear Experts

Is it ok to delete the last few requests of a delta enabled dso and then manually load each request from psa again?

Am i right there is no limit how many times i can do this?

A dso was having invalid characters when loading from it to a cube.

I tried to edit the one errorneous record and save but system says missing dtpr request.

What causes this may i know?

So, i would like to try reloading to the dso as i suspect a request in it was missing.

Is there a way to tell what happened to the missing request?

Regards

Pascal

Accepted Solutions (1)

Accepted Solutions (1)

srikanthbwbw
Active Participant
0 Kudos

Hi,

Is it ok to delete the last few requests of a delta enabled dso and then manually load each request from psa again?

Am i right there is no limit how many times i can do this?

Yes you can do it N number of times as long as there is requests in PSA

A dso was having invalid characters when loading from it to a cube.

I tried to edit the one errorneous record and save but system says missing dtpr request

You cannot edit the records whic are already in the cube. There might be some mismatch between properties of mapping in the transformation or routine between cube and DSO. Correct the records in the source and load. Usually if the data inside the cube is good and only target DSO having the invalid char issue, then it should be problem in transformation or check the master data chars.

Thanks

Srikanth

Answers (2)

Answers (2)

former_member210253
Contributor
0 Kudos

Hi Pascal,

Before the deleting request in the targets it should better, turn the request status as Red.Then only in the PSA it shows ''Request not updated''.

And after deleting u need to maintain the DTP delta settings.

Regards,

Babu.

Former Member
0 Kudos

hi , I think you may delete the request both in cube and ods. Then check the status of this request in PSA, it should be like 'not updated' . Then try to fix the character in PSA, and upload the request again.