on 08-29-2012 4:46 AM
Hi,
Am doing Post installation for RAR (GRC AC 5.3)
In Configuring (Configuration -> Connectors )JCo Connectors Section:
System Type: SAP
Connection Type: Adaptive RFC
JCO Destination: ? ( No JCo connectors are available in dorp down menu)
I was not able to see any connectors in JC0 Destination dropdown menu..
We have created and tested successfully the JCo connectors, which was done as part of installation.
Please advice me on this...
Thanks
Hi Arun,
One more thing to add , you are unable to see any Jco connectors in the Jco destination tab is because, you might have created your own Jco connector in webdynpro and not used the Standard Jco Connectors which SAP provides. Please maintain the Jco VIRSAXSR3 for Model and Metadata to resolve the issue.
Refer 1537033 note.
Regards,
Yukti
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Arunachalam,
In addition to what Yukti suggested-
For instance- for system SYS1 001 you may JCo VIRSAXSR3_01_MODEL VIRSAXSR3_01_META,and the RAR drop down should show xyz_SYS1_001.
For system SYS2 001 you may JCo VIRSAXSR3_02_MODEL VIRSAXSR3_02_META, the RAR drop down should show abc_SYS2_001.
Kind Regards,
Saksham
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Arun,
Please refer the below mentioned notes:-
1236183 - CC/RAR- Unable to create JCO destination
1715410
1589049
1524057
Regards,
Yukti
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Arunachalam,
Kindly check SAP note 1537033-Acceptable Conventions for Jco Destinations in RAR.
Kind Regards,
Saksham
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.