Message not seen in SXMB_MOni

[Former Member]

Hello Friends,

I have configured FILE-to-RFC Scenario. The file is simple xml file which is mapped to RFC. I have done repository and Directory Configuration. Polling of file is happening but the file is lost. I dont see any messages in SXMB_MONI.

Please suggest what can be wrong.

Thanks&Regards,

[Former Member · Accepted solution]

Hi,

Set the Logging Parameters in sxmb_adm.

Integration Engine Configuration -> specifc Configuration

RUNTIME Parameter (so i have it ) :

LOGGING = 1

LOGGING_SYNC = 1

TRACE_LEVEL = 3

TRACE_LEVEL_PROPAGATION = 1

Regards,

Robin

[Former Member]

Hello Friends,

It was basically http port issue. Which I changed using Exchangeprofile. Thanks for your help and time.

Regards,

Dipali

[Former Member]

Hello Chris,

I have configured receiver agreement also.

With sender service:LEGACY_System

receiver service : B1

Interface : BAPI_STSRVAPS_SAVEMULTI2

communication channel : xi2rfc

Thanks&Regards,

Dipali

[cdumont69]

Hello,

Check this link to known if there is a problem with your adapters :

http://<XISERVER>:50000/AdapterFramework/monitor/monitor.jsp

Or : RWB->Component Monitoring->Adapter Monitoring

Depending on your SP.

Regards,

Chris

[Former Member]

Hello Chris,

Adapter is up and running it picks up the xml file. Actually what i found out is that the http port in XI system is 8001 and the path where the xml is posted is

" The message was successfully transmitted to endpoint http://<server>:8000/sap/xi/engine?type=entry using connection AFW."

Can this be the problem?

How can I change 8000 to 8001.

Thanks&Regards,

Dipali

[cdumont69]

Yes it could be your problem, see this post :

Regards,

Chris

[Former Member]

Hi Dipali,

Please go to Runtime Workbench and trace the incoming message, i think Polling of file is happeneing, but the process is failing before reaching the integration server.

I hope this helps,

Thanks and Regards,

Varun Joshi

[cdumont69]

Hello,

Can you see it in IDX5 ?

Regards,

Chris

[Former Member]

Hello Chris,

I cannot see messages in IDX5.

Regards,

Dipali

[cdumont69]

Ok so try to enabled le log level as said Robin Schroeder.

And then check if your queue are empty or if there some locked message.

Could you describe us your ID conf ?

Regards,

Chris

[Former Member]

Hello Chris,

I have checked the queues through SMQ1 & SMQ2 they are empty. I can seen the message through Message Monitoring.

But receiver service is not visible for the same.

My ID configuration is as follows:

Business System : B1 and Legacy_system

Sender Agreement:

Interface : PRODUCT_LOCATION_IT

communication channel : filesender.

Receiver determination:

Receiver service : B1

Inbound interface : BAPI_STSRVAPS_SAVEMULTI2

Mapping : PRODLOC_IM

Receiver Channel: xi2rfc

Thanks&Regards,

Dipali

[cdumont69]

Perhaps you forget it in your post but do you create a receiver agreement ?

Regards,

Chris