Skip to Content
0
Jul 30, 2012 at 02:12 PM

Validation of project type at WBS level 2

193 Views

Hi everyone!

I'm trying to validate the project type only at level 2 of WBS elements but the validation is not working properly. If I manually trigger the validation in CJ20N, the error message is issued. But if I just save the project, no message is issued. But changes are not saved. That is to say, I change the project type so as to get an error message, I save, no error is issued, but when I check the WBS element again, the project type is not changed. The original project type remains.

The validation works fine if WBS element level is 1, but not 2. Strange. Did anyone have this problem before?

Here's the validation I'm using:

Pre-requisite:

( SYST-TCODE = 'CJ01' OR SYST-TCODE = 'CJ02' OR SYST-TCODE = 'CJ20N' ) AND ( PRPS-STUFE = '2' )

Validation:

PRPS-PRART <> '3F'

Thanks in advance!

Regards!