on 07-09-2012 10:47 AM
Dear SAP,
In QM view it seen that in one plant the insp.Setup tab is visible ,but on other plant for same material the insp.setup tab is not visible what may be the reason fro that.
Regards,
Asif
If you want to activate any inspection type, try using QA08, whether system allows or not. If you don't find this material in QA08, it means material is not extended to the plant.
Did you check whether you have any missing authorization?
AR
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
HI Asif,
It is possible that in MM01 it was missed for this perticular plant.
Go to MM02 and try to check the radio button to active "Inspection Setup".
SG
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Asif,
I hope, you've entered Organizational Levels (i.e. Plant & Stor Loc) correctly while displaying/changing material master... 🙂 or else QM view is not extended.
Regards,
Anup
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Asif,
Perhaps the material is not extended to that plant. Try using MM01 for QM view for this plant. If still not then check with /nsu53 for both MM01/MM02 transactions to verify if this is an authorisation issue.
Regards, Anand
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
99 | |
11 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.