plant not getting copied over to the PO from PR

[Former Member]

hello ,

The plant is not getting copied over to the PO when the user creates a PO from ME57. it was happening before but does not happen anymore? what could be the reason?

[BijayKumarBarik · Accepted solution]

Hi,

Are you able to save PO without Plant?

Check Plant in PR and just cross check t.code:OX10 and see that plant there and in see that plant assigned to company code in t.code: OX18

When you run earlier , did you got plant during PO from ME57?

Is this problem happening  now !

Check details seeting for quota arrangement.Refer links

http://scn.sap.com/thread/3164032

http://scn.sap.com/thread/1752740

Regards,

Biju K

[Former Member · Accepted solution]

nope! user has to go back to the requisition copy the plant in the PO and save it. Earlier the plant was getting copied over per user , however i am not sure if the same plant was getting copied.

[former_member186100 · Accepted solution]

hi Jack ,

Kindly check if the source( outline agreement ) assigned to PR is creating for blank plant or a plant different than PR.

cheers

Avinash

[Former Member · Accepted solution]

hi avinash,

There is no outline agreement assigned to PR , user is manually assigning the source .

[former_member186100 · Accepted solution]

well I don't see any reason then for Plant code not getting copied. Please sit with your technical consultant to see if you have done some enhancements whose side effect is preventing data flow. check If this problem is user id specific? or you can simply raise issue to official SAP support.