Skip to Content
avatar image
Former Member

How to set key Dist. demand (planned) to input/ouput format?

Dear all,

Can i set key Dist. demand (planned) in SNP planning book to input/output format?

I have tried to go to design mode --> Selected row --> input/output

But there is a message

Key figure <Distribution Demand (Planned)> must not be set to ready for input

And i have another question. In planning book, if i set a value into key figure Dist. receipt (planned), the system will automatically create a purchase requisition and a relevant stock transport requisition. So, if i can set the key figure Dist. demand (planned) to input/output format, then when i set a value into the key figure Dist. demand (planned), does the system automatically create a stock transport requisition and a relevant purchase requisition?

Thanks very much,

Thai.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Best Answer
    Jun 29, 2012 at 08:09 AM

    Hello Thai,

    You can not set the key figure into inputable. This is not supported by SNP.

    PR (STR) in SNP is initiated from receiving location instead of supplying location.

    If you input a value in distribution receipt, the order will be displayed as PR at receiving location side and STR at supplying location side -- but the vice versa is not applicatble.

    Best Regards,

    Ada

    Add comment
    10|10000 characters needed characters exceeded