on 06-11-2012 3:45 PM
Hi team,
ECC6, SQL under windows env.
After system refresh ECC6 PROD to STAGING system, I am trying to go in BW 7. and check source system connection with STG system i am getting an error BW unknown system
I run BDLS after system refresh, works fine but when I check Table T000 or SCC4 shows logical clients that ok too
see Table view RSBASIDOC still show old PROD entry there,
I think BDLS did not change the entry, so I try to run BDLS again but I am getting this error
"The new Logical system ZERSCLNT300 (staging system) is assigned to the current client 300"
My Question is why BDLS did not work again and what should I do to it will work again ?
also can i change manual modify table RSBASIDOC ?
Please verify
Thanks
Hi Angeline,
I think you may need to revisit your BDLS run procedure. As stated above by Ruchit, BDLS run gives option to select tables to convert. Better to select "*" for all tables containing Logical system fields.
regards
Vishal
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Vishal,
I think BDLS wasn't run properly last time, so thats why in table RSBASIDOC table still shows PROD entry;
I tried to run BDLS again using "Tables to be Converted" with "*" as you explain it but I got a message:
"The new logical system name ZERSCLNT300 is assigned to the current client 300
could you please tell me what should I do now
Thanks for your time
Angeline
Hi Angeline,
This is coming because value ZERSCLNT300 would be the there in T000 field LOGSYS when MANDT=300 i.e in simpler terms logical system ZERSCLNT300 has got assigned to client 300 already.
This is a warning and can be ignored because at the end of BDLS is a simple update statement but which is controlled by a condition where clause i.e it will update only those field values where production logsys is found.
Anyways here is what I suggest. Execute BDLS only for RSBASIDOC (give only RSBASIDOC as tables to be converted) initially. If this resolves the issue well and good. If not you have to look for alternative solution.
Also if I remember correctly * is not a must particularly given that the fields are not parameters but select option.Even blank would be taken as "*".
Regards.
Ruchit
No, you have to run BDLS from same client. You need to put new client name in SCC4 & start BDLS.
Just press "enter" when everything grayed out & you should be able to proceed.
Regards
Vishal
Hi Angeline,
Did you try to run BDLS for RSBASIDOC exclusively and explicitily. As you know BDLS gives you the option to run it for select few tables.
Regards.
Ruchit.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
88 | |
10 | |
10 | |
9 | |
6 | |
6 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.