Inspection lot MICS values copying into batch chars

[Former Member]

Hi,

I have activated Batch valuation w/o material specs & linked MIC & Batch char. But when i complete UD for inspection lot, these values are not being copied into Batch. Could some one reply me where i am missing

Regards

[former_member42743 · Accepted solution]

In configuration, in the QM plant settings.

On the inspection completion tab, make sure the check box "batch valuation without material spec." is ticked on.

FF

[Former Member]

If you are using Task list then you need customization aforesaid.

If you are using task list & have above config ,then make sure that all MIC's are created with class char & same char are assigned in the material master as well & all MIC's are valuated ,cloased before UD taken.