on 06-06-2012 9:07 AM
Dear Sap,
i have a scenario such that i receive 300 qty for inspection ,after inspection it conclude that 100 qty are Grade A & 200 qty grade B.So while posting how can i post Grade A material & Grade B material.Note Batch management is not maintain.
Regards,
Asif
Very much depends upon your requirement ,you can post Grade A or Grade B in different pockets ,like
say you can use "other material" ( 309 mvt type ) .
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
I guess it depends on what you mean by "see this two material differently".
They are two differeent material numbers. So you can do use MMBE to review stock levels.
If you want to historically see how they got created, the stock posting log in the inspection lot should log all posting related to the inspection lot.
And for custom reports you might be able usse the material documents.
It would be much easier if this was batch managed material. Then you coudl use the batch-where used lists and batch cockpit.
FF
Hi Anand Rao & Sujit,
Is it possible to create the inspection lot for the material which r laying in block stock, so that i can inspected again and give the different Grate.If yes the which inspection type should i used.Pls tell me the steps for such process.
Regards,
Asif
Shall we assume grade A material as OK and grade B material as non conforming? Since material code is same you can not have 2 different material codes at the time of posting.
If earlier is the case, post 100 into unrestricted and remaining in to block stock. You can do this in QA32 / QA11
Regards,
Anand Rao
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.