Report is not fetching data from Input Schedule

[Former Member]

Hi,

I'm working on a scenario in BPC 7.5 NW where I fill in planning data in an Input Schedule and later view the results/totals in a Report. Unfortunately, this Report is not showing the necessary data that it was supposed to fetch from the Input Schedule. The Current View is fine, but even then all fields are blank. What seems to be the problem?

Thanks,

Harini.

[raghu_ram · Accepted solution]

Hi Harini,

Please check in the back end BW System if the data is there or not.

Regards,

Raghu

[Former Member · Accepted solution]

Yes Raghu, the records exist in the back-end BW system. But it is not visible in the front-end Report.

[former_member182766]

Hi! I suggest you check ST22 for any abap dumps at the back end BW.

Just in case.

[Former Member]

Hi Vadim,

I just checked ST22. There're no runtime errors, no abap dumps.

Thanks,

Harini.

[former_member182766]

Hm. Okay. Have you tried restarting .NET server and checking it again?

[Former Member]

No changes occured. The report is still blank.

[former_member391412]

Hi Harini,

Could you able to resolve the issue. I'm facing the same issue in EPM10.

Experts any input on the same?

[former_member210696]

Hello Harini,

Was the data successfully submitted through input schedule. Did you get a popup window showing the success of data submission?

Regards,

Ashish

[Former Member]

Yes Ashish, I did get a pop window stating that all records were accepted; there were no rejected records.

[former_member210696]

Hello Harini,

Once the data is submitted to the database through an input schedule, it goes to the infocube and any report will fetch the data from the BI infocube and not from the input schedule.

Ensure that you are keeping the same set of dimension members in your report which you kept in input schedule for sending the data.

Can you post the screen shot of both report/input schedule.

Hope it helps.

[Former Member]

Hi Ashish,

I have attached 2 screenshots: 1 of the Input Schedule and the other of the Report.

I had enabled all macro content too, since initially I had thought it to be due to Macro security settings, but it's not.

Thanks for your quick response