P0008 is only taking direct valuated wage type

[Sanky]

HI Expert,

P0008 is only taking direct wage type value and rest indirect evaluate wage types are showing as zero.

Where is the problem?

Regards,

Sankarsan

[Former Member]

Hi,

Are u talking about SE16 data base table then here all Indirect valued wagetype will show zero amount. If you want to take this data base table for some Z-development then take function module what has been suggested by Sikandar.

The same logic has been applied in the satandard report

S_AHR_61015608 - Payments and deductions

[Sujith_EM]

Please check the configuration that you have done for the wage types in configuration - T511 and T539J.

If indirect valuation showing zero , please check what is the base wage type for the indirect valuation and the base wage type have a value in IT0008

[Sanky]

Hi,

table T511 and T539J is maintained properly.In IT8 is coming correctly but while run the payroll in payroll log under WPBP input table P0008 is showing only direct wage type value but indirect valuated wage type is showing zero.

Regards,

sankarsan

[Former Member]

Hi,

Under edit basoc data WPBP Input table P0008 all indirect valuated wage type will show zero amount with I indicator. But In the out put under IT it will show the full amount. Pl. check the same in the payroll log.

[sikindar_a]

Yes , you are right

P0008 will takes only direct values if , you want to check Indirectly valuated wage types use FM

RP_FILL_WAGE_TYPE_TABLE 

[Sanky]

Hi Sikindar ,

How i will use this FM.

Regards,

sankarsan