Skip to Content
avatar image
Former Member

SNP Optimizer Run not reading source location for one order

Hi All

I run optimizer distribution planned at source location is different from Distribution receipt at Destination.

When i check details at Destination one order is not showing source location.

Distribution Demand Planned showing orders at SOurce 962,904,962

Distribution Demand Receipts showing orders at Destination 962,904,2000

Qty 1038 is missing at SOurce for keyfigure distribution Demand Planned,when i check detail for qty 2000,qty 1038 dont have a source location its blank.

kindly guide me in this regard



Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • May 04, 2012 at 02:14 PM

    Hi Poorna,

    Something is limiting your source capacity due to which the optimizer is unable to load the t.lane fully. Assuming you would have defined only one source, the optimizer would have created SNP stock transfer with no reference to a source of supply.

    Please check the following link for details under SNP Opitmizer section.


    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Rajesh Jagadeeswaran

      Hi Poorna,

      Please check how the order with qty 1038 is created, you can check the optimizer logs.

      I think optimizer may not have created that order.



  • May 04, 2012 at 04:11 PM

    Hi Poorna,

    Out of the 2000,qty  at destination only1038 don't have a source location...and 962 has a source.Does it mean two orders exist at destination and only one order at Source(for 962)?

    Most probably this order would have been created in a different run or perhaps manually.(Check for 'Fixing indicator').Please check the optimizer log --It will show the number of orders created and quantity...If this don't help,you might need to raise a customer message with SAP,perhaps with a 'reproducible example'

    Thanks and Regards


    Add comment
    10|10000 characters needed characters exceeded