Material type ZCUS is not defined for task list type Q

[former_member216607]

Dear Sap,

     I am facing a problem in Z-type material.I seen that when i make inspection plan for Z- type material it not allowed to make and give an error (Material type ZCUS is not defined for task list type Q)which i solved.But it also give the problem in Material Master View,it seen that the tick are not mark on char ,sampling procedure, etc.But in std material type its mark already.So how to solve this problem for Z-Type material type.Because i am maintaining all this data one by one for all material.

Best Regards

Asif

[Former Member · Accepted solution]

Are you talking about the QM view -->inspection type ticks

[former_member216607 · Accepted solution]

Dear Sujit Gujar,

    No that we have to activate.at bottom of inspection type,we have different tick like Post to Inspection, Task list,Insp char, Sampling Procedure,Manual Evaluation.I talking about this tick.

[Former Member · Accepted solution]

That's what I was refering to dear.....those are populated from the QCC3--->inspection lot creation-->default valuses for inspection type--->here you maintain these values.

Make a note here that ,these values are not depend upon "Material type".

[former_member216607 · Accepted solution]

Dear Sujit Gujar,

Thanks for your valuable reply, I will checked and then back to you.

Best Regards,

Asif