Skip to Content

Info Idoc received with status 8

Hi Gurus,

I am trying to load the data from SAP ECC . I am getting the following error.

"Info Idoc received with status 8" .

This is happening across the board , means that i am not able to make any load from ECC.

This is simple full load for 0Material_attr . It's in Dev . In ECC RSA3 i can see there is some

data . That means BW should pull the data . I checked whole SDN and google.

I already followed all the suggestions.

1) Activate & replicate

2) No errors in SM50,SM21, WE20 , SM58.

Could any one help.

Thanks

Magge

Add a comment
10|10000 characters needed characters exceeded

Related questions

4 Answers

  • Posted on Apr 12, 2012 at 04:21 AM

    Hi magge,

    Check the data is coming to RSA 3 or not and also check whether any code is there at R3 level and also check selections at infopackage level.

    In my project also for a particular load, it will give the same message "IDoc message with status 8" when the table doesn't contain data according to my selections.

    regards,

    anand.

    Add a comment
    10|10000 characters needed characters exceeded

  • Posted on Apr 12, 2012 at 03:08 AM

    Hi

    If the datasource contains the data, then it should not get the Info IDoc message with status 8. Plz once the data in the datasource.

    Regards,

    RaviChandra

    Add a comment
    10|10000 characters needed characters exceeded

  • Posted on Apr 12, 2012 at 08:36 PM

    Hi Magge,

    1. What is the status of extraction job in R/3 side? In the job log, check if data is extracted or not?

    2. What is the status in Details tab of the IP?

    3. Check RFC connections

    4. Are you triggering this load manually or running as part of chain?

    Regards

    Chandu

    Add a comment
    10|10000 characters needed characters exceeded

  • Posted on Jul 20, 2016 at 08:15 AM

    Hi Magge,

    0MATERIAL_ATTR is an ODP supported data source, you can just import the data source in source data store and similarly import your data source in target data store as you are pushing data to 0material_attr.

    Thanks

    Anand

    Add a comment
    10|10000 characters needed characters exceeded

Before answering

You should only submit an answer when you are proposing a solution to the poster's problem. If you want the poster to clarify the question or provide more information, please leave a comment instead, requesting additional details. When answering, please include specifics, such as step-by-step instructions, context for the solution, and links to useful resources. Also, please make sure that you answer complies with our Rules of Engagement.
You must be Logged in to submit an answer.

Up to 10 attachments (including images) can be used with a maximum of 1.0 MB each and 10.5 MB total.