DUMP LOAD DATA BY DTP TO CUBE

[former_member1335810]

Hello,

environment:

BW 701 - EHP1 - SP 0008

Personnel can load the data using the Extractor 0CO_OM_CCA_1 ecc, but when I run the DTP to take data for the cube have a short dump when updating.

Has anyone seen anything like this?

In the dump does not say much, as compared programs in the environments. The problem only occurs in production.

Erro tpo.exec.         UNCAUGHT_EXCEPTION

Exceção                CX_RSR_X_MESSAGE

Regards,

Thiago M.

[hugo_amo]

Hi Thiago,

Without the whole dump it is quite difficult to know the cause. However, I have seen this dump in the past and Note 1157796 helped resolve it. Even though you are using SP8, I think if you try the suggestion as described in Symptom section it might solve it. However, as I said, it is just a hint.

"

The technical characteristic 0REQUEST must reference the technical characteristic 0REQUID.

The characteristic 0REQUEST is used in DataStore objects and characteristic 0REQUID is used in InfoCubes. Both characteristics must share the same master data ID (SID) number range.

"

If it does not work, provide more details.

Regards,

Hugo

[former_member186082]

Hi Thiago,

Load is dumping due to data being not caught. Debug the program which is dumping.

Paste the dump details completely if you can

Regards

Chandu