Skip to Content

Capture SOAP fault message

Hello, Could you please suggest if we need to implement any note to capture SOAP fault message. Currently we have PI 7.11 system. What kind of standard fault message strucuture should be defined. Do we need to implement note 1533195 to capture the SOAP . Is it mandatory ? Thanks

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Best Answer
    Apr 10, 2012 at 01:49 PM

    >Do we need to implement note 1533195 to capture the SOAP . Is it mandatory ? Thanks

    Only If your target system is in no soap mode & has returned a fault message in synchronous business scenarios, then you need to implement the above note. Because the response comes in different format.  Otherwise you don't need and follow the below.

    Generally, if your target system supports fault message and If you open wsdl and you will see whether you get responses both (happy flow - good response) and fault message (during application errors).  If your wsdl has request,response and fault, use them in Inbound service interface. similary you create one fault message on the sender outbound interface. Map the request, response and fault message for sender and target as usual. That's it. If the target system does not support fault message, you cannot retrieve the fault message response.

    Hope that is clear.

    You might want to check this link too

    http://scn.sap.com/people/shabarish.vijayakumar/blog/2006/11/02/fault-message-types--a-demo-part-1

    Add comment
    10|10000 characters needed characters exceeded