IDES ERP 6.0 Enh Pack 5 (ABAP-AS) and XSS with EP 7.02 SP3 (JAVA-AS)

[Former Member]

Hi,

I installed IDES ERP 6.0 Enh Pack 5 (ABAP-AS) and XSS with EP 7.02 SP3 (JAVA-AS) in same server.

I configured with SSO between Portal and R/3, and maintained the relevant JCo Destinations.

However, when I tried to test ESS/MSS under IDES JAVA, we encountered a lot of problems:

1. Under ESS, the pages are blank for many functions, like Who's who, personal information, etc... However, PDF form, like Total Compensation can be displayed.

2. Under MSS, many pages shown 500 error.

Is there installation/setup guide for HCM IDES with XSS(ESS, MSS, etc) ?

Thanks.
Edward Tso

[siddharthrajora · Accepted solution]

are you planning to use EHP5 WD ABAP iviews in the portal.

then you have to activate switches for ehp5!  Please check the roles.Read the note 1450179

and check your support packages level, they should be compatible

[Former Member · Accepted solution]

Hi Siddharth Rajora,

How can I activate switches for ehp5 ?

I got Error 404 in the ESS tabs. Pls advise.

Thanks.

Edward Tso

[siddharthrajora · Accepted solution]

You can do so via SFW5, and check the switches you want to activate can be checked in note below

Note  1450179 will give switches to activate

http://help.sap.com/erp2005_ehp_05/helpdata/en/25/340b0507434193adbfe3f8fc8896c7/frameset.htm

[Former Member · Accepted solution]

Hi Siddharth Rajora,

I ran with SFW5 and found that most of the switches for ehp5 are already activated. But still got Error 404 in the ESS tabs. Pls advise.

Thanks.

Edward Tso

[siddharthrajora · Accepted solution]

Yes, i can see the switches activated.

can you launch these services from se80 and see the behavior?

also can you check here the installation requirements

http://help.sap.com/erp2005_ehp_05/helpdata/en/25/340b0507434193adbfe3f8fc8896c7/frameset.htm

[Former Member · Accepted solution]

Hi Siddharth Rajora,

I tried to add 'administrators' group to the test account and found that some functions such as 'leave request' can be started properly. But some functions retruned with 'Page not found or not available'

Pls refer to below screens captured. Pls kindly advise.

Thanks.

Edward Tso

[siddharthrajora · Accepted solution]

this is still using JAVA WD, are you planning to WD ABAP iviews or still sticking to EHP4?

The error above is due to missing URL of PCD for the particular resource

check the services in the homepage customisation and the role