SET Events in Control profile

[Former Member]

Hi All ,           I have defined the Set event in the control profile for the Capacity levelling , In the Control profile system is asking the parameters , What is the Parameter i have to enter , Should i enter CYAA, CYB like this or the Name of the Capacity levelling profile . I have Created the Events(CY_PLANNING_TABLE_END)  in the T-code SM62 ,And I have Created the back round job also ,

As per SAP library , Once i save the plaaning table , system will trigger this event to do the Capacity levelling , Here System will consider the Orders i have Dispatched /Deallocated ??? or Will it consider the all the Orders which is having the particular dispatched/Deallocated work ceters ??

How to use this Event to trigger the levelling of particular orders or group of orders using this work center ???

Thank You

[Former Member]

Hello, I have read the documentation on Mass Processing, and am hoping to use the Event to trigger further dispatching, however, I do not have a clear picture of all the steps required.

If you were able to resolve the issue, how did you go about it?

Thank you very much,

Masha