Skip to Content
avatar image
Former Member

Smartform not printing the the edge

Hello experts

I am facing an irritating problem with my smartform


* Layout 210 * 297 mm

* Device type: HPLJ4


I have a logo which is 210 mm wide

This means that the logo is filling the whole page width.

When I am printing the smartform the printer is moving the logo 40-50 mm from the left page edge, and therefor is the logo being cutted in the right edge.

I have tried in TC: SPAD for the output device, on the tab: <Output attributes> to add a horizontal move-. That that is working fine for the left edge, but the logo is now being cut at approx. 100 mm from the right edge. So that is not the solution.

I have tried to upgrade the HP driver - that did not help.

I have also tried to change the device type from HPLJ4 to POST2. That worked perfectly – almost.

No edges are being cut. But the font OCR-B is not supported for the device type.

So have you experts any good suggestions for my problem?

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Best Answer
    avatar image
    Former Member
    Mar 16, 2012 at 09:27 AM

    The case is closed.

    We changed the logo - by cutting the egdes of the picture

    Add comment
    10|10000 characters needed characters exceeded