Skip to Content
avatar image
Former Member

How to remove Mass negative stock from Interim Storage 914

Hi,

There is a mass of negative stock in Interim storage type 914 after good issue.

So is there any easy method rather than doing it using LT01 ?

Your direction will be highly appreciated.

Regards,

Rock

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Best Answer
    avatar image
    Former Member
    Mar 14, 2012 at 01:28 PM

    Hi

    If the process is followed correctly there should not be a negative, the stock is posted from 914 but when you 'pick' the stock it should go TO 914 and so one cancels out the other

    I hope that this helps

    Frenchy

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Hi

      It is difficult to tell without seeing the system!!

      There should be a requirement to put stock in to 914 to balance out the negative

      Frenchy

  • avatar image
    Former Member
    Mar 15, 2012 at 09:59 AM

    Hi Rock,

    -ve stock is allowed in interim storage type. If you wish not to have -ve stock in interim you may deactivate the settings at storag type.

    SPRO>LE>WM>Master Data > Storage type

    Well , first you see the total stock for each material (for which -ve stock exists) at WM as well as at IM level. Compare both the stock , it should match in that case you can move +ve stock to -ve & knock-off that entry , if not you need to move the stock to differences i.e.to storage type 999.

    Afterwards try to analyse why & how -ve stock is getting generated. May be you can post your observation & you will get an answer for correction.

    Thanks,

    Mahesh

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Mar 15, 2012 at 04:37 PM

    Hi

    Check LB10 to see if there is a Transfer requirement that needs to be processed to 'pick' the stock and move it in to 914 to remove the negatives.

    Something must have triggered the negatives, It could be an issue against a production order ?

    This will consume the stock from an interim st type but if the stock is not there it will create the negatives.

    If this is the case then there should be a TR and then you create a TO and when confirmed it will send the stock to 914 and clear the negatives

    If you want a transaction to clear them on mass then LT10 will work but really you should find the cause and 'fix' it with the correct process

    I hope that this helps

    Frenchy

    Add comment
    10|10000 characters needed characters exceeded