Skip to Content
avatar image
Former Member

No data in Business Process Analytics after setting up BPA and BPMon


I have followed the BPA set up guide and done all the configuration for BPA. I have set up BPMon for a solution and in the logical component node i have done configuration for many application monitors.

Also in the "Load Master Data" node the master data is loaded. But still in BPA when I am selecting the time frame and applying it I am getting a message that no data is applicable in the selected time frame.

How can i get the data in BPA.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • avatar image
    Former Member
    Feb 24, 2012 at 06:52 AM


    Sometimes it requires patience 😊 I know in our case I needed to wait for the monitor to collect data few times to get data into BPA. If you don't have to deliver it until today, then I believe that there is a good good chance that on Monday morning data will be there.



    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hi Jolanta,

      I think patience is required. But I am still not getting the data.

      I have got 2 systems one is Solman 7.0 and the other 7.1. I Solman 7.0 BPA was already set up previously for one solution. after trying for sometime I am getting the data for that solution set up earlier but not for my new solution which I set up last week.

      So the problem is that in 7.0 I am getting data of one solution which set up few months ago bu m not getting the data of the solution I set up last week. And in 7.1 I am not getting any data.

      I dont think it should take this long to get the data.


      Edited by: Vishal Prajapati on Feb 27, 2012 10:19 AM

  • avatar image
    Former Member
    Feb 24, 2012 at 09:32 AM

    Hi Vishal,

    1435043 - E2E Workload Analysis - No applicable data found

    specially section 3) EFWK Resource Manager Job, wehre you find several

    hints to check this job and the EFWK Adminsitration.

    Also check note: 894279 Background processing in SAP Solution Manager

    Please have a look at following chapter of the the BPA Setup

    guide to fully understand the data flow in this application:

    2 Architecture of Business Process Analytics

    > 2.1 Data Retrieval and Reporting

    Please also review following chapter, in to see if there are any errors

    extracting the data from the managed systems to SAP Solution Manager:

    3.2.3 Checking status of Solution Manager Diagnostics Extractor

    Framework (EFWK)

    Also check:

    1570282, 1643303 and 1602437




    Add comment
    10|10000 characters needed characters exceeded