Skip to Content
0

One MIC is rejected in results recording, valuation should display as reject

Dec 26, 2016 at 07:27 AM

113

avatar image
Former Member

Hi QM Experts,

If even one MIC is rejected in results recording, the valuation should display as reject for inspection point valuation in valuation pop up screen during saving the operation in QE11 transaction.

one-mic-is-rejected-valuation-should-display-as-re.jpg

Regards

Chandra

10 |10000 characters needed characters left characters exceeded

I'm sorry, but in your screen prints I don't see any rejected MIC's.

What you are talking about is standard functionality in SAP.

i'm not sure where to guide you because I see nothing wrong. You have all accepted MIC's. Maybe that is the problem. You might want to check to see what kind of valuation procedure you are using on the MIC's.

Craig

0
Former Member

Hi Craig,

Now i had kept the screenshots in which one MIC is rejected. If one MIC is rejected, during saving operation in valuate inspection points, valuation should display as rejected. Please let me know enhancements available for this issue.

one-mic-is-rejected-valuation-should-display-as-re.jpg

Regards

Chandra

0
* Please Login or Register to Answer, Follow or Comment.

3 Answers

Siva G Jan 05, 2017 at 08:38 AM
0

Hi I am looking into similar kind of enhancement for changes Valuation of Inspection point as "Reject" if any one of the MIC line is reject i.e. cross mark (X) . in which Chandra has mentioned in his last screen shot. Is it possible to do it via ABAP enhancement ?

Share
10 |10000 characters needed characters left characters exceeded
Dipeshkumar Bhavsar Jan 05, 2017 at 11:38 AM
0

Hi Chandra,

I can see a similar thread. Hope It can help.

https://archive.sap.com/discussions/thread/3346586

Regards,

Dipeshkumar Bhavsar

Show 1 Share
10 |10000 characters needed characters left characters exceeded
Former Member

Hi Dipesh,

The thread which you have send does not match my requirement.

My requirement is If one MIC is rejected, during saving of operation in valuate inspection points, valuation should display as rejected in results recording (QE12 transaction).

Please let me know enhancements available for this issue. You can check the screenshots for clarification in my previous mail.

Regards

Chandra

0
Craig S
Jan 06, 2017 at 10:44 PM
0

This is defined in the inspection point configuration.

In SPRO: QM-->Qualtiy Planning-->Inspection Planning-->General-->Define Identifier for Inspection Points.

In here on the valuation tab, you define the default valuations for inspection points.

Then in the inspection plan, (QP02), on the operation overview screen, close to the bottom you define that inspection point valuation should happen automatically.

S


onllu.png (28.5 kB)
1scgb.png (126.4 kB)
Share
10 |10000 characters needed characters left characters exceeded