Cannot add new Key Figures to an Existing DataSource in RSA1

[Former Member]

Hi Guys,

I am running APO 7.0 and have an existing POS called MPOS01. It is up and running and I am prototyping a new feature to our solution in the sandbox. I have added 2 new key figures to MPOS01 and also added them to our backup cube. However, I am having difficulty adding these to the DataSource so I can set up the link between the backup cube and the datasource. If I go to RSA2 and look at my datasource, I can see my 2 new key figures. However, in RSA1, when I look at the datasource I cannot see them.

I have been trying to get this working for a while and do not know what to do so any suggestions/ideas would be much appreciated

Thanks and regards

Mark

[Former Member · Accepted solution]

Hi Mark,

You will need to replicate your data source again with /SAPAPO/SDP_EXTR. Run the repair and check after.

Once youdone this you should be able to to see your new key figures.

Then you will need to go through and add KF's to data cubes and update all of the transfer rules.

Regards

Paul

[Former Member · Accepted solution]

Hi Paul,

Thanks for your reply. I tried what you suggested and it is now working

Thanks very much for your help

Mark