Skip to Content
avatar image
Former Member

PI 7.3 and Netweaver BPM

Dear PIers,

We are planning to upgrade SAP PI 7.0 to SAP PI 7.30 Dual stack version. We did not go to "Single Stack" since we did not want to migrate existing 400 interfaces to the single stack architecture at the same time and we wanted to migrate them one by one.

If we upgrade to SAP PI 7.30 Dual stack, will we be able to use the SAP Netwever BPM?. This will help us to make sure that we are one step ahead for migrating to single stack apart from migrating from ABAP based adapters to Java based adapters.

is anyone planning to go to PI 7.30 Dual stack and gradually migrate BPE based interfaces to SAp Netwever BPM before converting the dual stack PI to single stack PI 7.31?.

Regards

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • Best Answer
    Feb 10, 2012 at 04:34 PM

    Having dual stack 7.3 installation for the existing BPM scenarios is wise decision at the moment. Though BPM uses BPMN standard not BPEL as that of CCBPM, still you might want to use as is in dual stack at this time. The Netweaver BPM integration with 7.3 is not completely aggressive yet. At this moment go with CCBPM and having dual stack should not impact the interfaces.

    Add comment
    10|10000 characters needed characters exceeded

  • Feb 10, 2012 at 04:40 PM

    Hi Arul,

    PI 7.3 dual stack not going to have SAP BPM,only single stack installation have different licensing models in the SAP BPM+Single stack is one installation mode,below blog you will get fair understanding.

    refer

    http://www.sdn.sap.com/irj/scn/weblogs?blog=/pub/wlg/28268

    Regards,

    Raj

    Add comment
    10|10000 characters needed characters exceeded