Skip to Content

Function module for calibration process

Dear all,

While performing calibration inspection, equipment status must be changed to not ready in use during usage decision based on the function module "qfoa_object_status_set" which is available in the QM_PM follow up action. But in my case its not happen eventhough I have customized in the following way

1) Tick both the check boxes (After posting and Syncronous update) available in the corresponding function module.

2) Assign the follow up action in the seleted set of catalog type 3

3) Creation of an equipment with equipment type category " Q"

What else I need to do? I didn't get any pop-up while taking usage decision. Kindly provide me the solution at the earliest.

Regards

Karthik

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • avatar image
    Former Member
    Feb 07, 2012 at 07:01 AM

    Hi

    Maintain the PRT view for category Q and try

    Regards

    Seenu

    Add comment
    10|10000 characters needed characters exceeded