No inspection lot could be generated for order

[Former Member]

Dear Guru's

Kindly help me in solving the below issue.

while creating the Service order at the time of release i got the below error.

No inspection lot could be generated for order.

Message no. IW217

Diagnosis

An inspection type has been defined for the order type in question. An inspection lot should be generated when the order is released. No inspection point field combination has been defined in any of the maintenance task lists used in the order. This is why no insepction lot can be generated.

Procedure

If an inspection lot is to be created, the order must contain at least one procedure which was taken from a maintenance task list and which has been define for one of the inspection point field combinations. This must be done before the order is released.

The same thing i checked in google .i found the below answer

Please check inspection point in task list header data. It should be 300.

In customizing please assign inspection type 14 to order type. For customization go to :

IMG -> Plant maintenance & Customer services -> maintenance and service processing -> Functions and settings for order type -> Assign inspection types to maintenance/ service order types

i have already done the above points but still i am getting the same error.kindly help me.

Thanks and Regards

suribabu

[Former Member · Accepted solution]

Hi

-->Maintain the inspection point 300 in the task list header(QM tab)

-->You should have maintain the sampling procedure check box in the MIC master

-->Select operation and click inspection char push button,assign MIC,Enter sampling procedure

-->now generate the new order or go to IW32 select the task list again,

-->Release and save

Regards

Seenu

[Former Member · Accepted solution]

Dear Srinu,

Thank you for your reply to me.

i am new to Customer Service part.currently in learning stage.

kindly elabrate more what is MIC Master.where i can able to check the same,either T code or path.

Thank u

suribabu

[Former Member · Accepted solution]

Hi Dnsbabu,

MICs are Master Inspection Characteristics. You can maintain them through t-code QS21.

[Former Member · Accepted solution]

hi

MIC means Master Inspection Characteristics i.e., what you need to inspect on a particular Equipment eg. Breadth so what is the breadth should be in a particular equipment here u can give lower limit and higher limit.

T.code for creating MIC is qs21 and here maintain all atributes and assign this to task list operation

for sampling procedure t.code is qdv1.

Regards,