cancel
Showing results for 
Search instead for 
Did you mean: 

Measuring Point

former_member306740
Participant
0 Kudos

Dear All,

I have entered measuring reading 40 and 600 against measuring point no (which have upper range limit and lower range limit is 500 and 50 respectively).

Hence system has created two notification of ZC type but the same is opening and showing the error as " OBJECT DOES NOT EXIST (STATUS MANAGEMENT).

Kindly guide me in this regard.

as iam new to this please explain me stepwise.

Regardss,

santosh.

Accepted Solutions (0)

Answers (2)

Answers (2)

former_member661330
Contributor
0 Kudos

Hi,

Can you create this notification manually?

This message is raise by SAP when you have not defined a status

Regards,

Carlos

former_member306740
Participant
0 Kudos

Hello,

When the measuring reading exceeds the notifications are creating with notification type ZC.

but when we go to IW23 and open it ,it will not open.

as per the SAP i have used this ZPMNOT_STATUS01 and updated database manually.

but every time it is not possible to update the database using that programme.

is ter any method available other than this.

Kindly guide me in this regard.

Regards,

santosh.

Former Member
0 Kudos

Hi

you can try the below Ehancement to acheive the Result, You can ask the abapers to activate the exit as per your requriement

for your scenario.

Enhancement IMRC0001 - for the creation of notification if reading exceeds the upper range using FM

BAPI_ALM_NOTIF_CREATE

BAPI_ALM_NOTIF_SAVE

EXIT_SAPLIMR0_001, CALL FUNCTION 'EXIT_SAPLIMR0_001' "User Exit Before Update of Measuring Points/Documents

Regards

Prakash

former_member306740
Participant
0 Kudos

Dear all,

the issue is resolved by calling following function module.

CALL FUNCTION 'STATUS_UPDATE_TASK_TRIGGER'

THANK YOU ALL.

closing the thread.

Regards,

santosh.

Former Member
0 Kudos
former_member306740
Participant
0 Kudos

Hi,

The mentioned notes are not working in my scenario.