LTP Run...

[Former Member]

I have create a planning scenario and put here receptive inactive version on that scenario. Requirement is there on that inactive version for those material. That can i see in MD61. So when I will run LTP by MS02, then no requirement will be calculated. Also when I have checked in MS04 , there are no planned order for requirement, only showing the opening stock.

Plz give me the solution how to run LTP with planning scenario with particular material and plant.

[former_member188931]

Hello,

First release the planning scenario (MS32) and then run MS01 or MS02 against the same.

please check and revert.

Thanks

Hrishi

[Former Member]

Hi,

Here the following steps for LTP run:

In MS31 we create a planning scenario.

MS32 PIR should be activated.

In MC87 rough cut planning (inactive version created).

Here we transfer the MC87 data to demand management in inactive version to MC74.

MS02 for single item, multilevel inactive version. We can not do the MRP planning run in MD02.

Go to MS04 run it.

In MS04 go to planned orders and click it on then go to change mode:

Menu:- GO TO -

---

> Capacity situation, Evaluation & Leveling.

Come back to MS32 to change LTP.

Scenario will be in inactive mode change to active mode by activating the Independent requirement.

We should have to give target screen a check box called CREATE LIST tick it.

Now you can see it in MD02 and MD04, because it is activated in demand management(MC74).

I hope it will helps you any queries please revert me back.

Regards,

Madhu.G

[former_member184655]

Dear Itsmyy,

check this link to understand more about LTP,if you can follow the steps you can resolve this issue,

Regards

Mangalraj.S

[anup_patil3]

Hi,

Have you set Planning Scenario Status to Released (Value=2).

Please check. Set it to Released & then run LTP run.

Revert if any further issue.

Regards,

Anup