Setting up IDOC AAE

[Former Member]

I got this blog as a reference in setting up IDOC Advanced Adapter Engine. [http://www.sdn.sap.com/irj/scn/weblogs?blog=/pub/wlg/20899] [original link is broken] [original link is broken] [original link is broken];

There's a note that "NOTE: In a dual-stack installation, we can use either the IDoc or IDoc_AAE adapter. "

However, our current setup is a dual-stack. The blog talks about setting up RFC Destination Configuration on NWA (since AAE is on the Java stack).

If we are on a dual-stack, is there still a need to setup RFC Destination Configuration on NWA if the same has been setup already in the ABAP side? Are the configs two entirely separate setups?

[Former Member]

If we are on a dual-stack, is there still a need to setup RFC Destination Configuration on NWA if the same has been setup already in the ABAP side? Are the configs two entirely separate setups?

Refer below link then you ll get good understand on IE and AAE on pi 7.3:

[DemoExamples|http://help.sap.com/saphelp_nw73/helpdata/en/71/21dfa45a5143ae9fe115f8c62b1801/frameset.htm]

and