Skip to Content
0
Former Member
Jan 03, 2012 at 07:48 AM

Using "messaging.system.queueParallelism.maxReceivers"

824 Views

Hi Experts,

Happy New Year 2012!!!

I am working in a landscape where there are integrations between 'CRM to MDM' and 'MDM to Non SAP Systems' using PI. There is a lot of data which flows through these interfaces and some times the PI MDM adapter clogs up and it stops both inbound and outbound data flow.

To address this issue we have been suggested to use "messaging.system.queueParallelism.maxReceivers" : Note - 1136790.

I was trying to collect some information on this but could only see scenarios using JDBC receivers. Hence i have a few questions to ask:

1.) Is this note only applicable to JDBC receiver scenarios? If yes, then can you please give a back ground as to why?

2.) If No, then how should i configure this in my PI system?

3.) How can i tag a particular scenario to this property? This is mentioned as a 2nd point in the note solution section but the steps are not given.

Thanks in advance,

Anshul