Skip to Content
0
Former Member
Jan 02, 2012 at 07:50 PM

PO Collab using PORDCR1 : Unable to trigger outbound Idoc on PO Change

509 Views

Hi All,

I have done the following config for sending PO's from ECC to PI:

a. Message Determination:

Application = EF

Output Type = BAPI

Program = BUS2012_ICH_R3

Form Routine = SEND_PORDCR1

Transmission Medium = 8 (Special Function)

Dispatch Time = 4 (Send Immediately)

Have maintained condition records for the desired vendors with Function == LS, Partner == Partner No. for SNC Logical system

b. Partner Profiles:

Maintained an outbound partner profile under SNC Logical System with the following details:

Message Type = PORDCR1

Receiver Port = PI Port

Basic Type = PORDCR102

Trasnfer Idoc Immediately == Yes

But I have not maintained any entries under Message Control

Error:

1. Able to successfully trigger Idocs for New POs created in ECC.

2. But there is no Idoc output when PO is changed / deleted.

3. For the Chnaged PO on clicking on Messages, can see an output entry after change but it is in the status "Not Processed"

Am I missing any addtional config for trigerring Idoc on PO Chnage / Deletion ?

Regards,

Bharath