Skip to Content
0
Jan 02, 2012 at 10:53 AM

ATD Check Issue in creation TLB Order Manually in Planning Book.

299 Views

Hi ,

I am facing issue in ATD Check in TLB Interactive Planning while creating TLB Order Manually.

Here goes scenario.

I am creating TLB Order Manually in TLB Planning Book with below Information.

Demand Date u2013 02.01.2012 ( Todayu2019s date ) & Qty u2013 20

Considering Lead Time of 10 Days to supply from Plant to Depot, Delivery Date in Purchase Order is calculated as 12.01.2012

Now I do outbound delivery for this PO in ECC. As client is not using Routes Transit Times functionalities, Planned Goods Issue Date for Outbound Delivery in ECC is calculated as Delivery Date from PO which is 12.01.2012 minus Transit Time in Route which is maintained as 0. Hence Planned Goods Issue Date in ECC is 12.01.2012.

This is same as Requirement Date for Outbound Delivery. PGI for this delivery is yet to happen. When PGI is done then issue is resolved.

When this Delivery goes in APO, it has requirement date as 12.01.2012 and now when I create TLB Order in Interactive Planning Book manually it allows me to create TLB Order of 20 qty extra before populating below message

u201CThere is only an ATD quantity of XXX available for product GHECP02u201D

In short it allows me to create 20 extra PO as Outbound Delivery is shifted to future bucketu2019s and hence is not counted in ATD Issues.

I am using Daily Bucket Profile in TLB Planning Book.

If I use Monthly Bucket Profile my issue is solved but again when client is creating TLB Order , by default system picks first date of bucket which client does not want.

Is there any way where in I can avoid this excess PO Creation. When it checks ATD Availability it should consider these outbound deliveries which are of future dates.

Regards,

Sameer