SLD Registration in SRM

[Former Member]

Hi All,

While installing our SRM server we chose "no SLD". We planned to register the SLD in SOLMAN later on. Currently SRM SLD is

up and running, but there are no data supplier in AS ABAP. We tried to run RZ70 by pointing to SRM Host And Gateways. It fails.

While RZ70 runs fine if we point to SOLMAN.

We want to understand how to register SLD of SRM in SOLMAN or if not needed can we have a local SLD in SRM configured now?

As we will be using EP 7.0; SLD is an integral part to make the things happen.

Some technical help or suggestions will be ueful for us.

Thanks & Regards,

Ishan

[Former Member · Accepted solution]

Hi Ishan,

We tried to run RZ70 by pointing to SRM Host And Gateways

- Is it throwing any error message?

We want to understand how to register SLD of SRM in SOLMAN

- If your Solman system is central SLD and you want SRM system to add in central SLD, you can do so by following steps in the below wiki.

http://wiki.sdn.sap.com/wiki/display/SMSETUP/Connect_Systems

You can find SLD configuration guide in the below link, if you want to make SRM as SLD.

www.service.sap.com/sld

Thanks,

Siva Kumar

[Former Member]

Hi All,

Thanks for your valuable replies

Ishan

[former_member128291]

Dear Ishan,

First of all you need to check your landscape design blueprint. If you are going to have a central SLD which is not going to be on your SRM system itself then you can configure your SRM data suppliers to the central system's SLD itself.

However, if you want to configure the data suppliers to your SRM system itself then first check what is the result on the page http://<hostname>:<port>/sld

As SLD should be installed by default so you would just need to do the SLD configuration as per the post-installation guide available at

This should help you out.

Regards,

Abhishek