Skip to Content
avatar image
Former Member

Issue with message in receiver determination

hello,

I have sent a IDOC message in PI and has reached in PI and can see it with IDX5.The message fails though with error no reciver found.

When I am in Receiver determination I do a test in the overview and seem there is no error seen.

So I am not sure where the error is coming from.

Thanks for the help.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

4 Answers

  • Best Answer
    avatar image
    Former Member
    Dec 12, 2011 at 04:05 AM

    Hi,

    1.If you created the Business System in the SLD, check whether it is having the Logical Name and it should be the in ID Business System --> Adapter Specific Identifiers.

    If it matches with that value, then activate and do the full cache refresh by using the url

    http://host:port/CPACache/refresh?mode=full

    2. Make some dummy changes to your existing receiver Determination --> Save --> Activate --> Check if cache updated properly.

    The above error normally occurs in case:

    1) Incorrect receiver name is maintained in RD

    2) Cache is not updated.....this is the most common reason

    3) Condition (if any in Receiver Determination) is not satisfied.

    Please go through below thread,

    No receiver could be determined

    regards,

    ganesh.

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Hi,

      1. check your operation mapping, which was given in interface determination and check service interface which was provided in operation mapping.

      please try to do test configuration in ID.

      take the payload and go to tools menu in ID their we have test configuration option just click on that give that payload and test it.

      you know that where the error is occured.

      2.everthing is fine. try to make some dummy changes and activate it. again yo have to refresh the full chache.

      i hope it will help you.

      regards,

      ganesh.

  • Dec 12, 2011 at 04:50 AM

    Hi,

    This type of error will come whenever the message is not satisfied with the conditon in Receiver Determination Step.

    please check your conditions in the Receiver Determination Step.

    GreatDay,

    Giri

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Dec 11, 2011 at 08:18 PM

    Hi,

    Is your object activated ?

    Is the cache correctly refreshed ?

    Regards,

    Horia

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      All the objects are activated and also the cache I have refreshed a couple of times.

      Error message is

      No receiver could be determined.

  • Dec 12, 2011 at 02:28 AM

    Dany,

    Can you verify you have defined the Sender Interface/namespace/Business System exactly similar to what you are seeing in SXMB_MONI?

    Also I believe you don't have any conditions/rules set in ur RD. If you do, then cross verify it again.

    Thanks!

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      hi,

      I run a test in the Receiver determination of the overview, the next window to the rules, the test is showing complete and nothing seems to be wrong there which is a simulation.

      The paypload is showing me no receiver determined.

      The receiver interface is showing black there and is only one which is the reciver BS and its interface.