No receiver could be determined

[former_member260907]

Hi Expert,

I have a proxy to file scenario. I am using integrated configuration in PI 7.3. In sender proxy CC, I used SOAP adapter type, XI 3.0 message protocol. In file receiver CC, I set it as normal. I checked every step in Integrated Configuration. When I send message from R3 proxy side, I checked message monitoring in R3, it sent out successful. But when I check sxmb_moni in PI, I got an error saying "No receiver could be determined". Can anybody throw me a light on where the issue is?

Thanks,

Charles

[markangelo_dihiansan · Accepted solution]

Hello,

But when I check sxmb_moni in PI, I got an error saying "No receiver could be determined". Can anybody throw me a light on where the issue is?

Have you followed the SAP How To Guide "How to Set Up the Communication between ABAP Backend and SOAP Adapter using XI Protocol"

http://www.sdn.sap.com/irj/scn/index?rid=/library/uuid/70066f78-7794-2c10-2e8c-cb967cef407b

Have you also checked the ID cache for successful activation by going to ID -> Environment -> Cache Status?

Hope this helps,

Mark

[former_member260907 · Accepted solution]

Hi Mark,

Thank you for the link. It is very helpful. I did not set up Sender ID in R3 sender side and did not set sap.com/com.sap.aii.af.soapadapter/XISOAPAdapterBean to sender proxy CC. However, after I followed the procedure, I still got the same error in PI sxmb_moni. I also clean and check the cache. Do you know if there is anywhere else I miss something?

Thanks,

Charles

[former_member260907 · Accepted solution]

Thank Mark. It works now.

Cheers.

[Former Member]

This message was moderated.