BPC 7.5 Client install on Windows 7, IE 9, "Not enough memory ...

[Former Member]

I have a new computer with Windows 7 Home, .NET Framework 1.1 with SP1 and Exporer 9. I am trying to load the MS Clients. The results are the message saying that I do not have enough (64MB) memory which I know is not true.

Earlier forum comment say that BPC 7.5MS is supposed to be compatible with Windows 7. What is the magic combination?

Edited by: Joseph Brady on Nov 30, 2011 5:20 PM

[Former Member]

If you want to use Internet Explorer 9 with BPC 7.5, you must have the most recent Service Pack, SP06, installed. Support for IE 9 was introduced with that version only. Anything less than that and you must use IE 8. Also, as the others said, make sure you have .Net 2.0 (with a minimum of SP1) installed. I would also make sure your Office installation is up to date.

Brian

[Former Member]

Hi Brian,

can you give me information where it is stated that IE 9 is only supported with SP06 or later. So far I've found only an error concerning the client installation within IE 9. Therefore SP06 provides a solution. I cannot find any official document that restricting the use of IE 9 to SP06 or later.

Regards

Christian

[Former Member]

Hi Christian

As per Brian's post, please make reference to SAP Note: 1603248 - Support for Internet Explorer 9 on BPC 7.x to confirm.

Kind Regards

Daniel

[former_member186498]

Hi Joseph,

before to install the client when you open the launch page click on the "Client Software Center" at the bottom and click after on the Client Diagnostic and test the feature you want to install. It's alerts you to possible lack of requirements.

Kind regards

Roberto

[Former Member]

Joe,

Hi there. Install guide states you need .NET Framework 2.0 SP1. Also make sure you are not using the 64 bit version of IE to access the Client Software Center. I have seen problems with that.