on 11-30-2011 1:22 PM
Hi Friends,
During usage decision, when i confirm 2 defects out of 6 pieces and raise a notification, i assume that 4 pieces will move to unrestricted use. (correct me if i am wrong). now what about the 2 defective pieces. what is the process for dealing with that.
thanks
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
In std SAP when notification is raised after defect recording ,stock does not move automatically to unrestricted.you have to move the desired stock to unrestricted via i QA11/12/QA32.
You can post the defective stock in block stock for rework or sent back to vendor by doing 122 mvt.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear Nandi,
i think you want to mention about reject quantity instead of defect quantity.
see, for rejecting 2 materials u must have observed some defects, those defects you will record while result recording. or (qf11)
notification can get created automatically.
1. QA32> select insp. lot> click on defects or results as per your requirement.
For posting your 4 OK pieces to Unrestricted you will have to go for Usage decision. (i hope, you are not using automatic stock posting).
2. QA32> click on Usage decision
Give Ud, and there will be tab "inspection lot stock". There you can post 4 pieces into Unrestricted and 2 Pieces into Blocked.
regards,
Edited by: Amolbook on Nov 30, 2011 2:46 PM
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
91 | |
8 | |
7 | |
4 | |
4 | |
3 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.