Skip to Content
0
Former Member
Nov 29, 2011 at 04:06 PM

Error Message through Dynamic Configuration length problem

248 Views

HI All,

We are trying to raise an error message with the help of Dynamic configuration in the Message mapping.

The need is to populate the message with certain variables.

However we are facing the problem that the message is getting truncated beyond a certain length.(Around 60 characters)

Similar custom messages in other interfaces are working fine for messages up to 100 characters.

Question:

1. What could be the maximum length for an error message in case of mapping failure?

2. What could be limiting the length of the message in our case?

Thank you for looking into this.

Regards,

Ankesh