Skip to Content
1
Nov 29, 2011 at 01:16 PM

CJE0 - Adding Characteristics - 'EXIT_SAPLPS01_002'

578 Views

i am trying to add a characteristics in the hierarchy report.

tcode: cje0

in this tcode, there are lot of reports, we can add the characteristics/selections and run the report.

the req is to add a characteristics in the hierarchy report, which will used to filter the reports.

everything works fine, i have additional charactertics 'COST CENTRE'.

the report works fine and the code in exit 'EXIT_SAPLPS01_002' also works fine.

but it fails to get the desc of the cost center in the report.

refer this post:

[urgent help needed reg. user exists..|urgent help needed reg. user exists..]

Edited by: ssm on Nov 29, 2011 6:47 PM