Failure of CVC creation via /SAPAPO/TS_PLOB_MAINTAIN

[Former Member]

Hello,

I want to generate CVC's via /SAPAPO/TS_PLOB_MAINTAIN and a variant.

In my selection condition in this program I choose one product. The button 'Number of Hits' shows a quantity of 4 CVC's.

After the execution of /SAPAPO/TS_PLOB_MAINTAIN I cannot find any CVC's on the Planning Object Structure with my specified product.

What can be the reason for this failure?

Thanks for answering and kind regards

Heinz Becker

[Former Member]

Hello,

thanks a lot for your help.

I try transaction mc62, but CVC's were not generated. I investigate that the CVC's were not valid - so, this was the reason why they are not generated.

However, thank you very much.

Kind regards

Heinz

[Former Member]

Hi,

thanks for your reply.

The CVC creation run in background and finished successfully. There are no problems with numeric material code - I recognized the leading zeros.

I do not know /sapapo/mc62 and I did not find it in the system (program which start via se38; transaction).

Do you have any other explanations?

Kind regards

H.Becker

[Former Member]

Hi,

as mentioned above try running the transaciton code /sapapo/mc62 and see if you are able to generate the CVCs.

regards

sandeep

[Former Member]

Please check the selection that you are using while running background job vis-a-vis manual entry like Check Selection tab

Thanks,

PM

[aparna_ranganathan]

Hi

Does the product have a numeric material code ? If so you have to put leading zeros to display the CVC's

Thanks

Aparna

[Former Member]

Can advise to check following:

1. When you run it manually via /sapapo/mc62 is it creating CVCs?

2. Do you run it in a background mode? Is it successfully finished?